NEC Univerge SV8100 - Page 425

UNIVERGE SV8100 Issue 5.0
Direct Inward System Access (DISA) 1 - 415
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
20-09-01 Class of Service Options
(Incoming Call Service) –
Second Call for DID/DISA/DIL/
E&M Override
Turns Off (0) or On (1) the
extension ability to receive a
second call from a DID, DISA, DIL,
or tie line caller.
. With this option set to 1, the
destination extension must
be busy for a second DNIS
caller to ring through. If the
destination extension does
not have a trunk or CAP key
available for the second call
and a previous call is ringing
the extension but has not yet
been answered, the second
caller hears busy regardless
of this program setting.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-13-23 Class of Service Options
(Supplementary Service) –
Display the Reason for Transfer
Select whether an extension
should display the reason a call is
being transferred to their
extension (Call Forward Busy, Call
Forward No Answer, DND).
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-14-01 Class of Service Options for
DISA/E&M – First Digit
Absorption (Delete First Digit
Dialed)
For tie lines, enable or disable the
ability to absorb (ignore) the first
incoming digit. Use this to make
the tie trunk compatible with
3- and 4-digit tie line service. This
option does not apply to DISA.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-14-02 Class of Service Options for
DISA/E&M – Trunk Group
Routing/ARS Access
This option enables or disables a
DISA or tie trunk caller ability to
dial 9 for Trunk Group Routing or
Automatic Route Selection (ARS).
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-14-03 Class of Service Options for
DISA/E&M – Trunk Group
Access
This option enables or disables a
DISA or tie trunk caller ability to
access trunk groups for outside
calls (Service Code 804).
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-14-04 Class of Service Options for
DISA/E&M – Outgoing System
Speed Dialing
This option enables or disables a
DISA or tie trunk caller ability to
use the System Speed Dialing.
0 = Off
1 = On
(default = 0 for
COS 1~15)
Program
Number
Program Name Description/Comments Assigned Data