NEC Univerge SV8100 - 47-08 Routing Mailbox Call Routing Options

Issue 5.0 UNIVERGE SV8100
1 - 416 Direct Inward System Access (DISA)
20-14-05 Class of Service Options for
DISA/E&M – Operator Calling
This option enables or disables a
DISA or tie trunk caller ability to
dial 0 for the telephone system
operator.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-14-06 Class of Service Options for
DISA/E&M – Internal Paging
This option enables or disables a
DISA or tie trunk caller ability to
use the telephone system Internal
Paging.
0 =Off
1 = On
(default = 1 for
COS 1~15)
20-14-07 Class of Service Options for
DISA/E&M – External Paging
This option enables or disables a
DISA or tie trunk caller ability to
use the telephone system External
Paging.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-14-08 Class of Service Options for
DISA/E&M – Direct Trunk Access
This option enables or disables a
DISA or tie trunk caller ability to
use Direct Trunk Access (Service
Code 805).
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-14-09 Class of Service Options for
DISA/E&M – Forced Trunk
Disconnect <Not for ISDN
T-point>
This option enables or disables a
tie trunk caller ability to use Forced
Trunk Disconnect (Service Code
3). This option is not available to
DISA callers.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-14-10 Class of Service Options for
DISA/E&M – Call Forward Setting
by Remote via DISA
Enable or disable a DISA caller
ability to use the Call Forward
service codes (Programs 11-11-01
~ 11-11-05).
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-14-11 Class of Service Options for
DISA/E&M – DISA/Tie Trunk
Barge-In
In an extension Class of Service,
enable (1) or disable (0) a DISA or
tie trunk user from using the
Barge-In feature.
0 = Off
1 = On
(default = 0 for
COS 1~15)
21-15-01 Individual Trunk Group Routing
for Extensions
Designate the trunk route
accessed when a user dials the
Alternate Trunk Route Access
Code. Refer to Trunk Group
Routing to set up outbound
routing.
0~100
(0 = No Setting)
(default = 0)
22-01-11 System Options for Incoming
Calls – VRS Waiting Message
Interval Time
Setup the duration time between
announcing the VRS Waiting
Message for Auto – Attendant &
Queuing. The message is
repeatedly sent out in the
specified time.
0~64800 (seconds)
(default = 20 seconds)
Program
Number
Program Name Description/Comments Assigned Data