NEC Univerge SV8100 - Page 427

UNIVERGE SV8100 Issue 5.0
Direct Inward System Access (DISA) 1 - 417
22-02-01 Incoming Call Trunk Setup For DISA operation, set the trunk
service type to 2. You can have a
different service type for each
Night Service mode.
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
22-04-01 Incoming Extension Ring Group
Assignment
Assign the extensions that should
receive the overflow. Set the
ringing in Program 22-06.
Maximum eight digits
Default:
Extensions 101~108
(first eight ports) ring
for incoming Ring
Group 1 calls. No
other extensions ring
for incoming Ring
Group 1 calls.
25-01-01 VRS/DISA Line Basic Data Setup
– VRS/DISA Dial-In Mode
Select whether the DISA trunk
uses the Extension number/
Service code specify (0) or the
Dial Conversion Table (1).
0 = Extension Number
Service Code Specify
(Intercom)
1 = Use Dial
Conversion Table
(default = 0)
25-01-02 VRS/DISA Line Basic Data Setup
– DISA User ID
Select whether or not the DISA
User ID is to be used.
0 = Off
1 = On
(default = 1)
25-01-03 VRS/DISA Line Basic Data Setup
– VRS/DISA Transfer Alarm
Select whether the DISA transfer
alarm should be used.
0 = Normal
1 = Alarm
(default = 0)
25-02-01 VRS/DISA VRS Message Assign the source and VRS
message number to be used as
the Automated Attendant
Message for each trunk (001~200)
which is assigned as a VRS/DISA.
0 = No Message
1 = 01~100 (VRS
Messages)
2 = 01~4 (ACI Group
Number)
3 = 01~64 (Extension
Group Number)
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data