UNIVERGE SV8100 Issue 5.0
Distinctive Ringing, Tones and Flash Patterns 1 - 451
Operation
To listen to the incoming ring choices:
1. Press Speaker.
2. Dial 811.
3. Dial 1 to check ringing for intercom calls.
- OR -
Dial 2 to check ringing for trunk calls.
4. For Intercom calls, select the pitch you want to check (1~8).
- OR -
For trunk calls, select the pitch (1~8) and the tone (1~4) you want to check.
5. Go back to step 4 to listen to additional choices or press Speaker to hang up.
To change the pitch of your incoming ring (multiline terminal only):
1. Press Speaker.
2. Dial 820.
3. Dial 1 to change ringing for Intercom calls.
- OR -
20-15-11 Ring Cycle Setup – VRS Waiting
Message Incoming
Call
Used to define the ringing cycle for
Incoming VRS Waiting Message.
Ringing Cycle = 1~13
(default = 6)
22-03-01 Trunk Ring Tone Range Set the ring tone range (1~9) for
each trunk.
0~8
(Ring Tone Pattern
1~4)
(Melody 1~ Melody 5)
(default = 0)
80-01-01 Service Tone Setup – Repeat
Count
Customize the system basic tones
and system service tones. You
need to reset for the changes to
take affect.
0~255 (0 = until
On-Hook)
Program
Number
Program Name Description/Comments Assigned Data
To Next Page
Loading...
