Issue 5.0 UNIVERGE SV8100
1 - 468 Drop Key
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-12-42 Service Code Setup (for Service
Access) – Flash on Trunk lines
Use to customize the flash on
trunk lines Service Codes.
SLT
(default = 806)
11-12-59 Service Code Setup (for Service
Access) – Trunk Drop Operation
for SLT
Use to customize the trunk drop
operation for SLT Service Codes.
SLT
(default not assigned)
14-02-03 Analog Trunk Data Setup – Flash
Type
Use this option to select the flash
type.
0 = Open Loop Flash
1 = Ground
Always set this option
for Open Loop Flash
(0)
(default = 0)
14-02-04 Analog Trunk Data Setup –
Hooking Type
This option lets you use Flash for
Timed Flash (Program 81-01-14)
or Disconnect (Program
81-01-15). (A user implements
Flash by pressing the FLASH key
while on a trunk call.)
0 = Timed Flash
(Hooking)
1 = Disconnect (Cut)
(default = 0)
15-02-05 Multiline Telephone Basic Data
Setup – Transfer Key Operation
Mode
If the Conf key should access
Flash, enter 2. Otherwise, enter 0
or 1.
0 = Transfer
1 = Call back
2 = Hook
(default = 0)
15-03-04 Single Line Telephone Basic
Data Setup – Flashing
Enables/disables Flash for single
line (500/2500 type) telephones.
0 = No
1 = Yes
(default = 1)
15-07-01 Programmable Function Keys Assign a function key for Drop Key
(code 84) if required.
Line Key 1~48
0~99 (Normal Function
Code 851 by default)
*00 ~ *99
(Appearance Function
Code) (Service Code
852 by default)
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
To Next Page
Loading...
