NEC Univerge SV8100 - Page 515

UNIVERGE SV8100 Issue 5.0
Flexible System Numbering 1 - 505
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-01-01 System Numbering – Service
Code
Customize the system internal
(Intercom) numbering plan.
Refer to Univerge
SV8100 System
Program Manual
11-02-01 Extension Numbering Assign extension numbers to
extension ports. The telephone
programming identity follows the
port number – not the extension
number.
Up to eight digits
1 200
2 201
3 202
~ ~
300 499
301 5000
~ ~
512 5211
11-04-01 Virtual Extension Numbering Assign virtual extension numbers. Up to eight digits
Default not assigned
11-06-01 ACI Extension Numbering Use to define the virtual extension
number to be used for the ACI
extension numbering.
ACI Ports: 1~96
(default not assigned)
11-07-01 Department Group Pilot
Numbers – Dial
Use to assign pilot numbers to
each Department Group set up
Up to eight digits
(default not assigned)
11-08-01 ACI Group Pilot Number Use to assign the pilot number to
the ACI Groups set in Program
33-02.
ACI Groups: 1~16
(default not assigned)
11-09-01 Trunk Access Code If required, change the single-digit
Trunk Access Code (normally 9). If
you change this code, you must
also review the settings in
Program 11-01-01 for the new
code selected.
Dial (up to four digits)
(default = 9)
11-09-02 Trunk Access Code – 2nd Trunk
Route Access Code
Assign the Service Code set up in
Program 11-01-01 for Alternate
Trunk Route Access.
Dial (up to four digits)
[default not assigned)]
11-10-01 Service Code Setup (for System
Administrator) – Night Mode
Switching
Use to customize the night mode
switching Service Codes for the
System Administrator.
MLT,SLT
(default = 818)
11-10-03 Service Code Setup (for System
Administrator) – Setting the
System Time
Use to customize the system time
Service Codes for the System
Administrator.
MLT
(default = 828)
11-10-04 Service Code Setup (for System
Administrator) – Storing
Common Speed Dialing
Numbers
Use to store common speed
dialing Service Codes for the
System Administrator.
MLT
(default = 853)