NEC Univerge SV8100 - Page 516

Issue 5.0 UNIVERGE SV8100
1 - 506 Flexible System Numbering
11-10-05 Service Code Setup (for System
Administrator) – Storing Group
Speed Dialing Numbers
Use for storing group speed
dialing numbers for the System
Administrator.
MLT
(default = 854)
11-10-06 Service Code Setup (for System
Administrator) – Setting the
Automatic Transfer for Each
Trunk Line
Set the service code for setting
automatic transfer for each trunk
line.
MLT
(default = 833)
11-10-07 Service Code Setup (for System
Administrator) – Canceling the
Automatic Transfer for Each
Trunk Line
Set the service code for canceling
automatic transfer for each trunk
line.
MLT
(default = 834)
11-10-08 Service Code Setup (for System
Administrator) – Setting the
Destination for Automatic Trunk
Transfer
Set the service code for setting the
destination for automatic trunk
transfer.
MLT
(default = 835)
11-10-12 Service Code Setup (for System
Administrator) – Night Mode
Switching for Other Group
Use to customize the night mode
switching for other group Service
Codes for the System
Administrator.
MLT
(default = 718)
11-10-16 Service Code Setup (for System
Administrator) – Leaving
Message Waiting (Requires CPU
to be licensed for Hotel/Motel)
Use to customize the leave
message waiting Service Codes
for the System Administrator
(requires CPU to be licensed for
Hotel/Motel).
MLT
(default = 726)
11-10-17 Service Code Setup (for System
Administrator) – Dial Block by
Supervisor
Use to customize the supervisor
dial block Service Codes for the
System Administrator.
MLT
(default = 701)
11-10-18 Service Code Setup (for System
Administrator) – Off-Premise
Call Forward by Door Box
Use to customize the night mode
switching Service Codes for the
System Administrator.
MLT
(default = 822)
11-10-20 Service Code Setup (for System
Administrator) – VRS - Record/
Erase Message
Use to customize the night mode
switching Service Codes for the
System Administrator.
MLT, SLT
(default = 716)
11-10-21 Service Code Setup (for System
Administrator) – VRS - General
Message Playback
Use to customize the VRS general
message playback for the System
Administrator.
MLT, SLT
(default = 711)
11-10-22 Service Code Setup (for System
Administrator) – VRS - Record or
Erase General Message
Use to customize the VRS record
or erase general message for the
System Administrator.
MLT, SLT
(default = 712)
11-10-23 Service Code Setup (for System
Administrator) – SMDR -
Extension Accumulated Printout
Code
Use to customize the SMDR
extension accumulated printout
codes for the System
Administrator.
MLT
(default = 721)
Program
Number
Program Name Description/Comments Assigned Data