NEC Univerge SV8100 - Page 517

UNIVERGE SV8100 Issue 5.0
Flexible System Numbering 1 - 507
11-10-24 Service Code Setup (for System
Administrator) – SMDR - Group
Accumulated Printout Code
Use to customize the SMDR group
accumulated printouts for the
System Administrator.
MLT
(default = 722)
11-10-25 Service Code Setup (for System
Administrator) – Account Code
Accumulated Printout Code
Use to customize the account
code accumulated printout Service
Codes for the System
Administrator.
MLT
(default = 723)
11-10-26 Service Code Setup (for System
Administrator) – Forced Trunk
Disconnect
Use to customize the forced trunk
disconnect Service Codes for the
System Administrator.
MLT, SLT
(default = 724)
11-10-27 Service Code Setup (for System
Administrator) – Trunk Port
Disable for Outgoing Calls
Define the service code which
should be used by an extension
user to block a trunk from being
used for outgoing calls.
MLT, SLT
(default = 745)
11-10-30 Service Code Setup (for System
Administrator) – Register
DECTPP
Use to customize the register
DECTPP Service Codes for the
System Administrator.
MLT
(default not assigned)
11-10-31 Service Code Setup (for System
Administrator) – Delete DECTPP
Use to customize the delete
DECTPP Service Codes for the
System Administrator.
MLT
(default not assigned)
11-10-32 Service Code Setup (for System
Administrator) – Set Private Call
Refuse
Use to customize the set private
call refuse Service Codes for the
System Administrator.
MLT, SLT
(default not assigned)
11-10-33 Service Code Setup (for System
Administrator) – Entry Caller ID
Refuse
Use to customize the entry caller
ID Service Codes for the System
Administrator.
MLT
(default not assigned)
11-10-34 Service Code Setup (for System
Administrator) – Set Caller ID
Refuse
Use to customize the set caller ID
refuse Service Codes for the
System Administrator.
MLT, SLT
(default not assigned)
11-10-35 Service Code Setup (for System
Administrator) – Dial-In Mode
Switching
Use to customize the forced trunk
disconnect Service Codes for the
System Administrator.
MLT, SLT
(default not assigned)
11-10-36 Service Code Setup (for System
Administrator) – Change the
Guidance Message Number on
Voice Mail Auto Attendant
Use to change the guidance
message number on voice mail
auto attendant Service Codes for
the System Administrator.
MLT, SLT
(default not assigned)
11-11-01 Service Code Setup (for Setup/
Entry Operation) – Call Forward
– All
Set the service code for setting call
forwarding all calls.
MLT, SLT
(default = 848)
11-11-02 Service Code Setup (for Setup/
Entry Operation) – Call Forward
– Busy
Set the service code for setting call
forwarding for busy calls.
MLT, SLT
(default = 843)
Program
Number
Program Name Description/Comments Assigned Data