NEC Univerge SV8100 - Page 529

UNIVERGE SV8100 Issue 5.0
Flexible System Numbering 1 - 519
11-15-09 Service Code Setup,
Administrative (for Special
Access) – Transfer to Incoming
Ring Group
When a call is transferred using
this service code, it is transferred
to the ring group destination for
that incoming trunk. For example,
trunk 2 is in Ring Group 4. When
the call is transferred using this
service code, the trunk rings all
extensions programmed for Ring
Group 4 or ring the External
Paging Group for Ring Group 4,
depending on how the system is
programmed.
(default not assigned)
11-15-11 Service Code Setup,
Administrative (for Special
Access) – Ethernet Port Reset
Use to customize the ethernet port
reset Service Codes.
(default not assigned)
11-15-12 Service Code Setup,
Administrative (for Special
Access) – Extension Data Swap
Ext. Data Swap = xxx (service
code in accordance with Program
11-01).
MLT
(default not assigned)
11-15-13 Service Code Setup,
Administrative (for Special
Access) – Remote Access from
DISA
Use to customize the service code
for Remote Access for DISA.
(default not assigned)
11-15-14 Service Code Setup,
Administrative (for Special
Access) – Modem Access
Assign the service code to be
used to access the internal
modem on the CD-CP00.
(default not assigned)
11-16-01 Single Digit Service Code Setup
– Step Call
Assign the Single Digit
(post-dialing) Service Codes.
(default not assigned)
11-16-02 Single Digit Service Code Setup
– Barge-In
Use this option to set up Item 02
for single digit Barge-In. For
example, you can assign Item 02
to use digit 5 for Barge-In. This
would allow you to program a
function key with an extension
number plus the Barge-In code
(i.e., 5). This allows one-touch
access to the Barge-In feature for
extension.
(default not assigned)
11-16-03 Single Digit Service Code Setup
– Switching of Voice/Signal Call
Use to customize the switching of
Voice/Signal call Service Codes
used when a busy or ring back
signal is heard.
(default = 1)
11-16-04 Single Digit Service Code Setup
– Intercom Off-Hook Signaling
Assign a one-digit service code to
be used for Off-Hook Signaling.
(default not assigned)
11-16-05 Single Digit Service Code Setup
– Camp-On
Customize the 1-digit Service
Code used for setting Camp-On.
(default not assigned)
Program
Number
Program Name Description/Comments Assigned Data