NEC Univerge SV8100 - Page 573

UNIVERGE SV8100 Issue 5.0
Headset Operation 1 - 563
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-11-62 Service Code Setup (for Setup/
Entry Operation) – Headset Ring
Volume Adjustment
If needed, change the service
code used to adjust the Headset
Ring Volume.
MLT
(default = 874)
15-02-41 Multiline Telephone Basic Data
Setup – Incoming Ring Setup
Determine if incoming calls ring
the speaker or headset.
0 = Speaker Normal
Ring
1 = Headset Ring
(default = 0)
15-02-42 Multiline Telephone Basic Data
Setup – Incoming Off-Hook Ring
Setup
Determine if incoming off-hook
ringing rings the speaker or the
headset.
0 = Speaker Off-Hook
Ring
1 = Headset Off-Hook
Ring
(default = 0)
15-02-43 Multiline Telephone Basic Data
Setup – Headset Ring Duration
If incoming ringing is set for
headset, set the duration the call
rings the headset before ringing
the speaker.
0 = No Switch to
Speaker Ring
1 = 10 seconds
2 = 20 seconds
3 = 30 seconds
4 = 40 seconds
5 = 50 seconds
6 = 1 minute
(default = 0)
15-07-01 Programmable Function Keys Assign a function key for Headset
Operation (code 05).
Line Key 1~48
0~99 (Normal Function
Code 851 by default)
*00 ~ *99
(Appearance Function
Code) (Service Code
852 by default)
20-02-05 System Options for Multiline
Telephones – Headset Busy
Mode
Set the conditions under which a
headset extension is busy to
incoming callers:
 The Headset extension is busy
to incoming callers when only
one extension appearance is
busy (0).
- OR -
 Headset extension is busy to
incoming callers only when
both extension appearances
are busy (1).
0 = No
1 = Yes
(default = 0)
20-02-12 System Options for Multiline
Telephones – Forced Intercom
Ring (ICM Call Type)
Determine whether intercom calls
should ring or voice-announce
extensions.
0 = Disable (Voice)
1 = Enable (Signal)
(default = 0)