NEC Univerge SV8100 - Page 579

UNIVERGE SV8100 Issue 5.0
Hold 1 - 569
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-12-30 Service Code Setup (for Service
Access) – Specified Trunk
Answer
If required, redefine the service
code used to answer a specific
trunk which is either ringing or on
hold.
MLT, SLT
(default = 772)
11-12-33 Service Code Setup (for Service
Access) – Group Hold
If required, redefine the service
code used to answer a specific
trunk which is either ringing or on
hold.
MLT, SLT
(default = 832)
11-12-34 Service Code Setup (for Service
Access) – Answer for Group
Hold
If required, redefine the service
code used to answer a specific
trunk which is either ringing or on
hold.
MLT, SLT
(default = 862)
14-01-16 Basic Trunk Data Setup – Forced
Release of Held Call
Enable (1) or disable (0) Forced
Release of Held Call.
0 = Disable
1 = Enable
(default = 0)
14-07-01 Trunk Access Map Setup Set up the Trunk Access Maps.
This sets the access options for
trunks.
0 = No access
1 = Outgoing access
only
2 = Incoming access
only
3 = Access only when
trunk on Hold
4 = Outgoing access
and access when trunk
on Hold
5 = Incoming access
and access when trunk
on Hold
6 = Incoming and
Outgoing access
7 = Incoming access,
outgoing access and
access when trunk
on Hold
Trunk Access Maps:
1~200
Default:
Access Maps 1~200 =
Trunk Ports 1~200
assigned with option 7
access (incoming and
outgoing access and
access when trunk is
on Hold).