NEC Univerge SV8100 - Page 634

Issue 5.0 UNIVERGE SV8100
1 - 624 ISDN Compatibility
SMDR Dialed Digits for either ISDN – BRI or PRI
General ISDN Programs
Program
Number
Program Name Description/Comments Assigned Data
35-02-15 SMDR Output Options – CLI/DID
Number Switching
Determine if the CLI/DID Number
should be displayed.
0 = CLI (CLIP)
1 = DID Calling
Number
(default = 0)
35-02-16 SMDR Output Options – Trunk
Name or Received Dialed
Number
Determine how the SMDR should
print incoming calls on ANI/DNIS
or DID trunks. If set to (1), ANI/
DNIS trunks can print DNIS digits,
if set to (0) trunk names are
printed instead.
. For additional SMDR
Services refer to Station
Message Detail Recording
on page 1-935.
0 = Trunk Port
Name
1 = Received
Dialed Number
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data
14-01-13 Basic Trunk Data Setup – Trunk-
to-Trunk Transfer
For each trunk that should be able
to participate in a tandem call,
enter 1. To disable a trunk from
Tandem Trunking, enter 0.
Required for 2 B-Channel transfer.
0 = Disable
1 = Enable
(default = 1)
15-02-29 Multiline Telephone Basic Data
Setup – PB Back Tone Level
This program option can be used
to adjust the PB Back Tone level
when calling an ISDN line.
1~63 (-15.5dB ~
+15.5dB)
(default = 32) 0db
15-07-01 Programmable Function Keys Assign a function key for Caller ID
Block for ISDN (63) if required.
Line Key 1~48
0~99 (Normal Function
Code 851 by default)
*00 ~ *99
(Appearance Function
Code) (Service Code
852 by default)
20-06-01 Class of Service for Extensions Assign a Class of Service to
extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1