UNIVERGE SV8100 Issue 5.0
Loop Keys 1 - 651
Operation
To place a call on a loop key:
1. Press outgoing or both ways loop key.
. You hear dial tone and the key lights green.
2. Dial number.
To answer a call on a loop key:
Listen for ringing a look for a flashing loop key.
1. Press loop key.
. The key lights green and you connect to the call.
. If there are additional calls waiting to be answered, your display shows:
. [WAITING - LOOP KEY]
To program a loop key:
1. Press the SPK key.
2. Dial 852.
3. Press the key you want to program as a loop key.
4. Dial *05.
5. Dial the loop key type:
o 0 = Incoming only
o 1 = Outgoing only
o 2 = Both ways (incoming and outgoing)
6. Dial the loop key routing option for incoming, outgoing, or incoming and outgoing calls:
o 000 = Trunk Group Routing or ARS (if installed)
o 001-200 = Trunk Groups
. If you selected option 2 in step 5 above, enter the incoming Trunk Group followed by the outgoing Trunk Group.
7. Press SPK to hang up.
To Next Page
Loading...
