NEC Univerge SV8100 - Page 746

Issue 5.0 UNIVERGE SV8100
1 - 736 Off-Hook Signaling
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-12-03 Service Code Setup (for Service
Access) – Override (Off-Hook
Signaling)
Assign a service code (809 by
default) to be used for Off-Hook
Signaling Override.
MLT, SLT
(default =809)
11-16-04 Single Digit Service Code Setup
– Intercom Off-Hook Signaling
Assign a one-digit service code to
be used for Off-Hook Signaling.
(default not assigned)
15-02-12 Multiline Telephone Basic Data
Setup – Off-Hook Ringing
For each extension, set Off-Hook
Ringing type: 0 (muted), 1 (none),
3 (beep in speaker), 4 (beep in
handset), 5 (Speaker & Handset
Beep). DID, DNIS and DIL trunks
can use any of the four options -
normal/ring group trunks can only
use options “0” or “1”.
0 = Muted Off-Hook
Ringing
1 = No Off-Hook
Ringing
2 = Not Used
3 = Beep in Speaker
(SP)
4 = Beep in Handset
(HS)
5 = Speaker & Handset
Beep
(default = 5)
15-07-01 Programmable Function Keys Assign a function key for Off-Hook
Signaling (code 33).
Line Key 1~48
0~99 (Normal Function
Code 851 by default)
*00 ~ *99
(Appearance Function
Code) (Service Code
852 by default)
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extension port =
Class 1
20-09-07 Class of Service Options
(Incoming Call Service) – Call
Queuing
Turn Off (0) or On (1) an extension
ability to have calls queued if a call
rings the extension when it is busy.
. Must be set to 1 to enable
automatic Off-Hook
Signaling.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-13-05 Class of Service Options
(Supplementary Service) –
Intercom Off-Hook Signaling
Turn On (1) or Off (0) the ability of
an extension to receive Off-Hook
Signals.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-13-06 Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
Allows a busy extension ability to
automatically (1) or manually (0)
receive Off-Hook Signals.
0 = Off
1 = On
(default = 1 for
COS 1~15)