NEC Univerge SV8100 - Page 752

Issue 5.0 UNIVERGE SV8100
1 - 742 One-Touch Calling
3. Dial 01 (DSS/One-Touch Key Operation).
4. For Direct Station Selection (Extension):
a. Dial extension number you want assigned to that key.
b. Press Hold.
c. Press Speaker.
For Personal Speed Dial:
a. Dial the general trunk access code (9).
- OR -
Dial the Specific Trunk Service Code (805) plus the trunk number (e.g., 005).
- OR -
Dial the Trunk Group Service Code (804) plus the trunk group number (e.g., 1).
b. Dial the number you want to store.
. The total of the digits stored in steps 3 and 4 cannot exceed 24.
. Valid entries are 0~9, # and *. To enter a pause, press MIC. To store a Flash, press Redial.
c. Press Hold.
d. Press Speaker.
For Speed Dial – System/Group:
a. Dial 813 to store a Speed Dial – System dialing number.
- OR -
Dial 814 to store a Speed Dial – Group dialing number.
b. Dial Speed Dial number storage code (e.g., 001).
c. Press Hold.
d. Press Speaker.