UNIVERGE SV8100 Issue 5.0
Paging, External 1 - 761
31-01-02 System Options for Internal/
External Paging – Page
Announcement Duration
Set the maximum allowable
duration for a Paging
announcement.
0~64800 (seconds)
(default = 1200
seconds)
31-03-01 Internal Paging Group Settings –
Internal Paging Group Name
Assign name to Internal Paging
Groups (i.e., Page Zones). The
system shows the name you
program on the telephone display.
Up to 12 characters
Refer to Programming
Manual for table.
31-04-01 External Paging Zone Group Assign each External Paging
Speaker to an External Paging
Group (1~8) used for accessing
the zone. If zones 1~8 are not
connected to PGD(2)-U10 ADP,
set these unused zones to
External Paging Group 0.
External Paging
Speaker/Zones: 1~9
Speaker 1 [PGD(2)-
U10] = 1 (Group 1)
Speaker 2 [PGD(2)-
U10] = 2 (Group 2)
Speaker 3 [PGD(2)-
U10] = 3 (Group 3)
Speaker 4 [PGD(2)-
U10] = 4 (Group 4)
Speaker 5 [PGD(2)-
U10] = 5 (Group 5)
Speaker 6 [PGD(2)-
U10] = 6 (Group 6)
Speaker 7 [PGD(2)-
U10] = 7 (Group 7)
Speaker 8 [PGD(2)-
U10] = 8 (Group 8)
Speaker 9 (CD-CP00)
= 1 (Group 1)
31-05-01 Universal Night Answer/Ring
Over Page
Assign Universal Night Answer
ringing to each External Paging
zone. For each trunk port, make a
separate entry for each External
Paging Speaker.
External Paging
Speaker/Zones: 1~9
0 = No Ringing (No)
1 = Ringing (Yes)
(default = 0)
31-06-01 External Speaker Control –
Broadcast Splash Tone before
Paging (Paging Start Tone)
Use this option to enable or
disable splash tone before Paging
over an external zone. If enabled,
the system broadcasts a splash
tone before the External Paging
announcement.
0 = No Tone (None)
1 = Splash Tone
2 = Chime Tone
(default = 2)
31-06-02 External Speaker Control –
Broadcast Splash Tone after
Paging (Paging End Time)
Assign option for each External
Paging Speaker (1~9).
0 = No Tone (None)
1 = Splash Tone
2 = Chime Tone
(default = 2)
31-06-04 External Speaker Control –
CODEC Transmit Gain Setup
Use to define the CODEC
transmitting gain settings for the
external speaker using an
amplifier.
1~63 (-15.5 ~ +15.5dB)
(default = 32)
Program
Number
Program Name Description/Comments Assigned Data
To Next Page
Loading...
