EasyManua.ls Logo

NEC Univerge SV8100 - Page 790

NEC Univerge SV8100
1174 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Issue 5.0 UNIVERGE SV8100
1 - 780 Park
15-18-01 Virtual Extension Key Enhanced
Options – Virtual Extension Key
Operation Mode
This program sets whether an
incoming call to a Virtual
Extension/CAR resides on the
Virtual Extension/CAR key once
answered (1) or appears on a CAP
Key/CO Appearance Line key (0).
This setting applies to Multiline
Terminals, single line telephones
and virtual extension numbers.
0 = Release
1 = Land On the Key
(default = 0)
15-18-02 Virtual Extension Key Enhanced
Options – Display Mode when
pacing a call on Virtual
Extension Key
Defines if calls to or from a Virtual
Extension Key display the Virtual
Extension Key name or the name
of the extension it resides on.
0 = Secondary
Extension Name
1 = Actual Station
Name
(default = 0)
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extension port =
Class 1
20-11-19 Class of Service Options (Hold/
Transfer Service) – Hold/
Extended Park
Determine whether an extension
Class of Service should allow
normal or extended Park
(0 = Normal, 1 = Extended).
0 = Off
1 = On
(default = 0 for COS
1~15)
20-11-24 Class of Service Options (Hold/
Transfer Service) – Trunk Park
Hold Mode
Set the hold type when a trunk call
is put on hold by an extension.
0 = Non Exclusive Hold
(Off)
1 = Exclusive Hold
(On)
(default = 1 for
COS 1~15)
20-11-25 Class of Service Options (Hold/
Transfer Service) – Transfer Park
Call
Turn on or off an extensions ability
to transfer a parked call.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-11-26 Class of Service Options (Hold/
Transfer Service) - Station Park
Hold Mode
Turn on th eability to park a call at
a co-worker’s extension.
0 = Off
1 = On
(default = )
20-11-27 Class of Service Options (Hold/
Transfer Service) – Call Park
Automatically Search
Use this option to turn On (1) or
Off (0) using the Call Park
Automatically Search option.
0 = Off
1 = On
(default = 1 for
COS 1~15)
Program
Number
Program Name Description/Comments Assigned Data

Table of Contents

Other manuals for NEC Univerge SV8100

Related product manuals