NEC Univerge SV8100 - Page 826

Issue 5.0 UNIVERGE SV8100
1 - 816 Q-Sig
DID Services for either ISDN – BRI or PRI
Program
Number
Program Name Description/Comments Assigned Data
22-02-01 Incoming Call Trunk Setup Assign the incoming trunk type for
each trunk.
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
22-09-01 DID Basic Data Setup – Expected
Number of Digits
For each DID Translation Table
(1~20), enter the number of digits
the table expects to receive from
the CO (eight maximum). For
example, for a table used with
3-digit DID service, enter 3.
For additional DID Services refer
to Direct Inward Dialing (DID) on
page 1-385.
1~8
(default = 4)
22-11-01 DID Translation Number
Conversion – Received Number
For each DID Translation Table
entry (1~2000), specify the digits
received by the system.
(maximum eight digits)
(default not assigned)
22-11-02 Translation Number Conversion
– Target Number
For each DID Translation Table
entry (1~2000), specify the
extension the system dials after
translation.
(maximum 24 digits)
(default not assigned)