NEC Univerge SV8100 - Page 827

UNIVERGE SV8100 Issue 5.0
Q-Sig 1 - 817
F-Route
Program
Number
Program Name Description/Comments Assigned Data
11-01-01 System Numbering Set the system internal (Intercom)
numbering plan. The numbering
plan assigns the first and second
digits dialed and affects the digits
an extension user must dial to
access other extensions and
features, such as service codes
and trunk codes. If the default
numbering plan does not meet the
site requirements, use this
program to tailor the system
numbering to the site.
Refer to SV8100
Programming Manual
for a detailed
description of this
program.
14-05-01 Trunk Group – Trunk Group
Number
Program trunks of the same carrier
type into the same trunk group.
Trunks 1-200
Trunk Group 1-100
Priority - 1-200
(default = All trunks in
Trunk Group 1 with
priorities of:
Trunk 1 = Priority 1
Trunk 2 = Priority 2
Trunk 200 = Priority
200)
44-01-01 System Options for F-Route – F-
Route Time Schedule
Select whether the F-Route
feature should use the time
schedule (0=not used, 1=used). If
this option is set to 0, the F-Route
table selected is determined only
by the digits dialed without any
relation to the day or time of the
call. If this option is set to 1, the
system first refers to Program
44-10. If there is a match, the
pattern defined in that program is
used. If not, the F-Route pattern in
Program 44-09 and time setting in
Program 44-08 are used.
0 = Not Used
1 = Used
(default = 0)
44-02-01 Dial Analysis Table for F-Route
Access – Dial
Set the Dial digits for the
Pre-Transaction Table for
selecting F-Route (eight digits
max: 1~9, 0
* #, @). To enter a
wild card/don’t care digit, press
Line Key 1 to enter an @ symbol.
Up to eight digits
(Use line key 1 for a
‘Don’t Care’ digit, @)
(default not assigned)
44-02-02 Dial Analysis Table for F-Route
Access – Service Type
Set the Service Type (0~3) for the
Pre-Transaction Table for
selecting F-Route.
0 = No Setting (None)
1 = Extension Call
(Own)
2 = F-Route Table (F-
Route)
3 = Dial Extension
Analyze Table (Option)
(default = 0)