NEC Univerge SV8100 - Page 829

UNIVERGE SV8100 Issue 5.0
Q-Sig 1 - 819
44-03-04 Dial Analysis Extension Table –
Next Table Area Number (252)
If the received digits do not match
the digits set in tables 1~250, table
number 252 is used refer to the
next Extension Table Area (1~4) to
be searched.
0~4
(default = 0)
44-04-01 F-Route Selection for Time
Schedule
Assign each F-Route Selection
number (1~500) to an F-Route
table number for each F-Route
time mode. There are eight time
modes for F-Route Access.
F-Route Time Mode:
1~8
F-Route Table Number
= 0~500
(default = 0)
44-05-01 F-Route Table – Trunk Group
Number
Select the trunk group number to
be used for the outgoing ARS call.
0~100, 255
0 = No Setting
255 = Extension Call
(default = 0)
44-05-02 F-Route Table – Delete Digits For each F-Route table (1~500)
assign a priority number (1~4).
Enter the number of digits to be
deleted (0~255) from the dialed
number.
0~255
(255 = Delete All)
(default = 0)
44-05-03 F-Route Table – Additional Dial
Number Table
For each F-Route table (1~500)
assign a priority number (1~4).
Enter the table number (defined in
Program 44-06) for additional
digits to be dialed (0~1000).
0~1000
(default = 0)
44-05-04 F-Route Table – Beep Tone For each F-Route table (1~500)
assign a priority number (1~4).
Select whether or not a beep is
heard if a lower priority trunk group
is used.
0 = Off (No Beep)
1 = On (Beep)s
(default = 0)
44-05-05 F-Route Table – Gain Table
Number for Internal Call
For each F-Route table (1~500)
assign a priority number (1~4).
Select the gain table number to be
used for internal calls (0~500).
0~500
0 = No Setting
(default = 0)
44-05-06 F-Route Table – Gain Table
Number for Tandem
Connections
For each F-Route table (1~500)
assign a priority number (1~4).
Select the gain table number to be
used for the tandem call (defined
in Program 44-07).
0~500
0 = No Setting
(default = 0)
44-05-07 F-Route Table – ARS Class of
Service
For each F-Route table (1~500)
assign a priority number (1~4).
Select the Class of Service to be
used for ARS (0~16). Extension
ARS COS is determined in
Program 26-04-01.
0~16
(default = 0)
44-05-08 F-Route Table – Dial Treatment For each F-Route table (1~500)
assign a priority number (1~4).
Select the Dial Treatment to be
used (0~15). The Dial Treatments
are defined in Program 26-03-01
0~15
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data