UNIVERGE SV8100 Issue 5.0
Repeat Redial 1 - 829
Operation
To use Repeat Redial (if the outside party you call is unavailable or busy):
1. Place a trunk call.
. Listen for busy tone or ring no answer.
2. Press Feature + Redial.
- OR -
Press the Repeat Redial key (Program 15-07 or SC 851: 29).
. Repeat Redial key flashes while you wait for the system to redial.
3. Press Speaker to hang up.
. The system periodically redials the call.
4. Lift the handset when called party answers.
. When using trunks with answer supervision the Repeat Redial feature automatically cancels.
To cancel Repeat Redial:
1. Press Feature.
2. Press Redial.
- OR -
1. Press Repeat Redial key (Program 15-07 or SC 851: 29).
(Also refer to Last Number Redial on page 1-633.)
21-08-03 Repeat Dial Setup – Repeat Dial
Calling Timer
Set how long the system waits for
the called party to answer after a
Repeat Redial. If the called party
does not answer in this time, the
system hangs up and tries again
(after the Repeat Redial Interval
Time). For unanswered calls, the
total time between retries is the
sum of Program 21-08-02 and
Program 21-08-03.
0~64800 (seconds)
(default = 30)
21-08-04 Repeat Dial Setup – Time for
Send Busy Tone for ISDN Trunk
Sets the time (sec) to send out
Busy Tone with an ISDN line,
when called party is busy.
0~64800 (seconds)
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data
To Next Page
Loading...
