NEC Univerge SV8100 - Page 878

Issue 5.0 UNIVERGE SV8100
1 - 868 Selectable Ring Tones
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-11-20 Service Code Setup (for Setup/
Entry Operation) – Change
Incoming CO and ICM Ring
Tones
If required, change the service
code used for changing the
incoming ring tones heard for CO
and ICM calls.
MLT
(default = 820)
11-11-21 Service Code Setup (for Setup/
Entry Operation) – Check
Incoming Ring Tones
If required, change the service
code used for checking how the
incoming ring tones sound.
MLT
(default = 811)
15-02-02 MultiLine Telephone Basic Data
Setup – Trunk Ring Tone
Use this option to set the tone
(pitch) of the incoming trunk ring
for the extension port you are
programming.
1 = High
2 = Medium
3 = Low
4 = Ring Tone 1
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
(default = 2)
15-02-03 Multiline Telephone Basic Data
Setup – Extension Ring Tone
Use this option to set the tone
(pitch) of the incoming extension
call ring for the extension port you
are programming. Also refer to
program 15-08.
1 = High
2 = Medium
3 = Low
4 = Ring Tone 1
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
(default = 8)
15-08-01 Incoming Virtual Extension Ring
Tone Setup
When an extension or a virtual
extension is assigned to the
function key on the key telephone,
select the ring tone when receiving
a call on that key.
For ACD CAR keys, only tone
pattern 1 (entry 0) can be used.
The remaining patterns are not
checked with this feature.
ICM Tone Pattern,
0 = Pattern 1
1 = Pattern 2
2 = Pattern 3
3 = Pattern 4
4 = Incoming Ring
Tone Extension
(default = 0)