NEC Univerge SV8100 - Page 879

UNIVERGE SV8100 Issue 5.0
Selectable Ring Tones 1 - 869
Operation
To change your extension incoming ring tones:
1. Press Speaker.
2. Dial 820.
3. Dial 1 to set Intercom ring; 2 to set trunk ring.
4. Dial code for the desired ring pattern (1~8).
5. Press Speaker to hang up.
15-10-01 Incoming Virtual Extension Ring
Tone Order Setup
When two or more virtual
extensions are set on a function
key on the telephone, and the tone
pattern by which the sound of
each extension differs, the priority
of ring sound is set up.
0 = Tone Pattern 1
1 = Tone Pattern 2
2 = Tone Pattern 3
3 = Tone Pattern 4
4 = Incoming Extension
Ring Tone
Order 1 Pattern 0 =
Pattern 1 (default)
Order 2 Pattern 1 =
Pattern 2 (default)
Order 3 Pattern 2 =
Pattern 3 (default)
Order 4 Pattern 3 =
Pattern 4 (default)
22-03-01 Trunk Ring Tone Range Select the ring tone range for the
trunk. The trunk uses a ring tone in
the range selected when it rings
an extension. Four ring tones are
available.
0~8
(Ring Tone Pattern
1~4)
(Melody 1~ Melody 5)
(default = 0)
1 = High 5 = Ring Tone 2
2 = Mid Range 6 = Ring Tone 3
3 = Low 7 = Ring Tone 4
4 = Ring Tone 1 8 = Ring Tone 5
Program
Number
Program Name Description/Comments Assigned Data