NEC Univerge SV8100 - Page 888

Issue 5.0 UNIVERGE SV8100
1 - 878 Single Line Telephones
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
10-03-01 ETU Setup (DLCA PKG Setup) –
Terminal Type (B1)
Program all on-premise single line
telephones with circuit type 2. Set
the DIOPU trunk to type 1 when
trunks should be defined for off-
premise extension (OPX) use.
0 = Not set
1 = Multiline Terminal
2 = SLT Adapter
3 = Bluetooth Cordless
Handset
6 = PGD (Paging)
7 = PGD (Tone Ringer)
8 = PGD (Doorbox)
9 = PGD (ACI)
10 = DSS Console
11 = -- Not Used --
(default = 0)
10-03-03 ETU Setup (LCA PKG Setup) –
Transmit Gain Level (S-Level)
Use to setup and confirm the
Basic Configuration data for each
blade.
1~63 (-15.5 +15.5dB)
[default = 32 (0dB)]
10-03-04 ETU Setup (LCA PKG Setup) –
Receive Gain Level (R-Level)
Assign transmit and receive levels
for single line telephones.
1~63 (-15.5 +15.5dB)
[default = 32 (0dB)]
10-09-01 DTMF and Dial Tone Circuit
Setup
If the system has DTMF single line
extensions, allocate at least one
circuit for analog extension DTMF
reception (entry 0 or 1).
Use the following as a guide when
allocating DTMF receivers:
 In light traffic sites, allocate one
DTMF receiver for every 10
devices that use them.
 In heavy traffic sites, allocate
one DTMF receiver for every
five devices that use them.
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource
01~08 = 1 (Extensions)
Circuit/Resource
09~32 = 2 (Trunks)
Circuit/Resource
33~96 = 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
15-03-01 Single Line Telephone Basic
Data Setup – SLT Signaling Type
Enter 0 if single line telephone is a
dial pulse. Enter 1 if single line
telephone is DTMF.
. In-Skin Voice Mail and InMail
set to 0.
0 = DP
1 = DTMF
(default = 1)
15-03-03 Single Line Telephone Basic
Data Setup – Terminal Type
Enter 1 for this option to allow a
single line port to receive DTMF
tones after the initial call setup.
Enter 0 to have the port ignore
DTMF tones after the initial call
setup. For Voice Mail, always
enter 1 (e.g., receive DTMF
tones).
0 = Normal
1 = Special
(default = 0)