NEC Univerge SV8100 - Page 889

UNIVERGE SV8100 Issue 5.0
Single Line Telephones 1 - 879
15-03-05 Single Line Telephone Basic
Data Setup – Trunk Polarity
Reverse
Do Not Change Default Entry as
DTMF issues may arise with voice
mail.
0 = Off
1 = On
(default = 0)
15-03-06 Single Line Telephone Basic
Data Setup – Extension Polarity
Reverse
Do Not Change Default Entry as
DTMF issues may arise with voice
mail.
0 = Disable (Off)
1 = Enable (On)
(default = 0)
15-03-07 Single Line Telephone Basic
Data Setup – Enabled On-Hook
When Holding (SLT)
Used to enable or disable Enabled
On-Hook When Holding for SLT
terminals.
0 = No
1 = Yes
(default = 1)
15-03-08 Single Line Telephone Basic
Data Setup – Answer On-Hook
when Holding (SLT)
Used to enable or disable Answer
ON-Hook when Holding for SLT
terminals.
0 = Disable
(No)
1 = Yes
(Enable)
(default = 1)
15-03-09 Single Line Telephone Basic
Data Setup – Caller ID Function -
For External Module
Enable (1) or disable (0) the Caller
ID FSK signal for an external
Caller ID module or a 3rd party
vendor telephone with Caller ID
display.
Important:
If voice mail is used, this setting
must be disabled for the system
integration codes to be correct.
With a DTMF set (no Caller ID)
installed, this must be set to 0 for
incoming callers to have a talk
path.
0 = Disable
1 = Enable
(default = 0)
15-03-10 Single Line Telephone Basic
Data Setup – Caller ID Name
Determine if an extension user
telephone should display the
Caller ID name.
0 = Disable
1 = Enable
(default = 1)
15-03-11 Single Line Telephone Basic
Data Setup – Caller ID Type
Determine whether the Caller ID
type is FSK or DTMF.
0 = FSK
1 = DTMF
(default = 0)
15-03-14 Single Line Telephone Basic
Data Setup – Forwarded Caller ID
Display Mode
Determine what the display shows
when a multiline terminal receives
a forwarded outside call.
0 = Calling Extension
Number (Calling)
1 = External Caller ID
(Forward)
(default = 0)
20-03-01 System Options for Single Line
Telephones – SLT Call Waiting
Answer Mode
For a busy single line telephone,
set the mode used to answer a
camped-on trunk call.
For ESL sets, enabling this option
(1) allows the user to dial Service
Code for Voice Mail Conversation
Record.
0 = Hookflash
(Hooking)
1 = Hookflash +
Service Code 894
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data