Issue 5.0 UNIVERGE SV8100
1 - 880 Single Line Telephones
20-03-02 System Options for Single Line
Telephones – Ignore Received
DP Dial on DTMF SLT Port
Use this option to define whether
the system should receive dial
pulse and DTMF signals (0) or
ignore dial pulse and only accept
DTMF signals (1).
0 = Do not ignore (No)
1 = Ignore (Yes)
(default = 0)
20-03-03 System Options for Single Line
Telephones – SLT DTMF Dial to
Trunk Lines
Set the SLT phones to (0). Collect
all digits before sending or (1),
send out immediately after
receiving. When using a
third-party external paging device,
set this option to 1. In addition, set
Program 20-03-04 to 1.
0 = Receive all digits,
before sending (All)
1 = Direct through out
(Direct)
(default = 0)
20-03-04 System Options for Single Line
Telephones – Dial Sending Start
Time for SLT or ARS
Set the time before the first digit is
sent out. When using a third-party
external paging device, set this
option to 1. In addition, set
Program 20-03-03 to 1.
0~64800 (seconds)
(default = 3 seconds)
20-03-05 System Options for Single Line
Telephones – SLT Operation
Mode
Used to define the Operation
Mode for SLT terminals.
0 = Normal Mode
1 = Extended Mode1
2 = Extended Mode2
(default = 0)
20-03-06 System Options for Single Line
Telephones – Headset Ringing
Start Time
Define the headset ringing start
time. After this time expires from
the time when a single line
telephone is off-hook, the system
sets the single line telephone to
headset ringing mode.
0~64800 seconds
(default = 5 seconds)
20-03-07 System Options for Single Line
Telephones – Trunk Call Dial
Forced Sending Start Time
(Forced Dial)
Used to define the Trunk Call Dial
Forced Sending Start Time.
0~64800 seconds
(default = 0)
20-06-01 Class of Service for Extensions Assign a unique Class of Service
for Dual OPX telephones only
when using Continued Dialing.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
20-13-13 Class of Service Options
(Supplementary Service) –
Continued Dialing (DTMF) Signal
on ICM Call
Turn Off (0) or On (1) an extension
user ability to use Continued
Dialing, which allows DTMF signal
sending while talking on
extension.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-15-01 Ring Cycle Setup – Normal
Incoming Call on Trunk
Define the ringing cycle (1~13) for
normal incoming trunk calls (DIL,
ring group, etc.).
Ringing Cycle = 1~13
(default = 8)
Program
Number
Program Name Description/Comments Assigned Data
To Next Page
Loading...
