NEC Univerge SV8100 - Page 902

Issue 5.0 UNIVERGE SV8100
1 - 892 SLT Adapter
20-08-13 Class of Service Options
(Outgoing Call Service) – ISDN
CLIP
Determine if the ISDN calling line
identity presentation and
screening indicators are to be
allowed.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-08-14 Class of Service Options
(Outgoing Call Service) – Call
Address Information
Used to enable or disable Call
Address Information for each
COS.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-08-15 Class of Service Options
(Outgoing Call Service) – Block
Outgoing Caller ID
Turn Off (0) or On (1) a user Class
of Service from automatically
blocking outgoing Caller ID
information when a call is placed.
If block is enabled, the system
automatically inserts the Caller ID
block code
*67 (defined in
Program 14-01-21) before the
user dialed digits (this requires
Program 14-02-10 to be enabled).
If block is disabled, the system
outdials the call just as it was
dialed by the user.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-08-16 Class of Service Options
(Outgoing Call Service) – Display
E911 Dialed Extension Name and
Number
Turn off or on an extension ability
to display the name and number of
the extension that dialed 911.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-08-17 Class of Service Options
(Outgoing Call Service) – ARS
Override of Trunk Access Map
Turn off or on an extension ability
to override the trunk access map
programming for outgoing calls.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-08-19 Class of Service Options
(Outgoing Call Service) – Hotline
for SPK
Turn off or on an extensions’
ability to activate hotline or
ringdown when pressing the
Speaker key.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-08-20 Class of Service Options
(Outgoing Call Service) – Hot
Key Pad
Turn On (1) or Off (0) the ability of
an extension to make a call by just
dialing the number without first
going off hook.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-08-21 Class of Service Options
(Outgoing Call Service) –
Automatic Trunk Seizing by
Pressing Speaker Key
Enable or Disable the ability of an
extension to automatically access
Trunk Route when going off hook
via the Speaker key.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-08-22 Class of Service Options
(Outgoing Call Service) – Voice
Over to busy Virtual Extension
Enable or Disable the ability of an
extension to make Voice Over to
Busy Virtual Extension.
0 = Off
1 = On
(default = 0 for
COS 1~15)
Program
Number
Program Name Description/Comments Assigned Data