NEC Univerge SV8100 - Page 920

Issue 5.0 UNIVERGE SV8100
1 - 910 Speed Dial – System/Group/Station
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
10-09-01 DTMF and Dial Tone Circuit
Setup
If dial tone detection is enabled, be
sure to allocate at least one circuit
for dial tone detection (Type 0 or
2).
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource
01~08 = 1 (Extensions)
Circuit/Resource
09~32 = 2 (Trunks)
Circuit/Resource
33~96 = 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
11-10-04 Service Code Setup (for System
Administrator) – Storing
Common Speed Dialing
Numbers
Used to customize the service
code used for storing Common
Speed Dialing Numbers.
MLT
(default = 853)
11-10-05 Service Code Setup (for System
Administrator) – Storing Group
Speed Dialing Numbers
Used to customize the service
code used for storing group speed
dialing numbers.
MLT
(default = 854)
11-11-39 Service Code Setup (for Setup/
Entry Operation) – Station Speed
Dial Number Entry
Used to customize the service
code used for entering station
speed dial numbers.
MLT, SLT
(default = 855)
11-12-10 Service Code Setup (for Service
Access) – Common/Station
Speed Dialing
Assign Service code for accessing
System Speed Dial bins (default
813).
MLT, SLT
(default = 813)
11-12-11 Service Code Setup (for Service
Access) – Group Speed Dialing
Used to customize the service
code for group speed dialing.
MLT, SLT
(default = 814)
11-12-40 Service Code Setup (for Service
Access) - Station Speed Dialling
Assign Service code for accessing
System Speed Dial bins (default
761).
MLT, SLT
(default = 761)
13-01-01 Speed Dialing Option Setup –
Speed Dialing Auto Outgoing
Call Mode
Designate trunk or intercom
outgoing mode, (default: 0, trunk).
0 = Trunk Outgoing
Mode
1 = Intercom Outgoing
Mode
(default = 0)
13-01-03 Speed Dialing Option Setup –
Number of Common Speed
Dialing Bins
Designate the bins the system
uses for System Speed Dialing.
0~2000
0 = No Common
Speed Dialing
(default = 1000)