NEC Univerge SV8100 - Page 921

UNIVERGE SV8100 Issue 5.0
Speed Dial – System/Group/Station 1 - 911
13-02-01 Group Speed Dialing Bins Designates the starting bin
number the system uses for Group
Speed Dialing.
01~64
(default not assigned)
13-03-01 Speed Dialing Group
Assignment for Extensions
For Group Speed Dialing, assign
extensions to Speed Dialing
groups (1~64).
01~64
(default = 1)
13-04-01 Speed Dialing Number and Name
– Speed Dialing Data
Enter the System and Group
Speed Dialing numbers and
names.
1~9, 0, *, #
Pause (Press line key
1)
Recall/Flash (Press
line key 2)
@ = Code to wait for
answer supervision in
ISDN (Press line key 3)
(maximum 24 digits)
(default not assigned)
13-04-02 Speed Dialing Number and Name
– Name
Assign a name to each System
Speed Dial bin.
Maximum 12
Characters (Use dial
pad to enter name)
(default not assigned)
13-04-03 Speed Dialing Number and Name
– Transfer Mode
When the incoming caller ID
matches the number programmed
in the speed dial bin, this setting
determines the destination of the
call.
0 = Not Used
1 = Internal Dial
2 = Incoming Ring
Group (IRG)
(default = 0)
13-04-04 Speed Dialing Number and Name
– Transfer Destination Number
When the incoming caller ID
matches the number programmed
in the speed dial bin, this setting
determines the destination of the
call.
If Transfer mode is
(Refer to 13-04-03):
1 = Internal Dial Mode
1~9, 0, *, #, P, R, @
(Maximum 24
Characters)
2 = Incoming Ring
Group
0 ~ 100 (IRG Number)
P=Pause R=Recall
@= Additional Digits
when using ISDN
functionality
(default not assigned)
13-04-05 Speed Dialing Number and Name
– Incoming Ring Pattern
Define the ring tone for the caller
ID routed call.
Incoming Ring Pattern
0 = Normal Pattern
1 ~ 4 = Tone Pattern
(1~4)
5 ~ 9 = Scale Pattern
(1~5)
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data