NEC Univerge SV8100 - Page 932

Issue 5.0 UNIVERGE SV8100
1 - 922 Speed Dial – System/Group/Station
2. For System Speed Dialing, press Redial.
Dial the Speed Dialing Code (e.g., common code 001).
. If the entire stored number is too long for your telephone display, press* to see the rest of the number.
- OR -
For Group Speed Dialing, press the Group Speed Dialing key.
- OR -
For System Speed Dialing key, press the System Speed Dialing key.
3. Press the Exit key.
. To display additional numbers, repeat from step 1.
To store a Station Speed Dialing number (display telephones only):
1. Press Speaker.
2. Dial 855.
3. Dial the Station Speed Dial buffer number to be programmed (0~9).
1 = Station Speed Dial buffer 1
2 = Station Speed Dial buffer 2
" " " " " "
0 = Station Speed Dial buffer 10
4. Dial the telephone number you want to store (up to 24 digits).
. Valid entries are 0~9, # and *. To enter a pause, press MIC. To store a Flash, press Recall.
5. Press Hold.
6. Enter the name associated with the Speed Dialing number (display telephones only).
Key for Entering Names
Use this keypad
digit . . .
When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
→ ← Á À Â Ã Ç É Ê ì ó
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.