NEC Univerge SV8100 - Page 933

UNIVERGE SV8100 Issue 5.0
Speed Dial – System/Group/Station 1 - 923
7. Press Hold.
8. Press Speaker to hang up.
To store a Station Speed Dialing number (Single Line Telephones only):
1. Lift the Handset.
2. Dial 855.
3. Dial the Station Speed Dial buffer number to be programmed (0~9).
1 = Station Speed Dial Buffer 1
2 = Station Speed Dial Buffer 2
3 = Station Speed Dial Buffer 3
4 = Station Speed Dial Buffer 4
5 = Station Speed Dial Buffer 5
6 = Station Speed Dial Buffer 6
7 = Station Speed Dial Buffer 7
8 = Station Speed Dial Buffer 8
9 = Station Speed Dial Buffer 9
0 = Station Speed Dial Buffer 10
4. Dial the telephone number you want to store (up to 24 digits).
. Valid entries are 0~9, # and *.
. A Single line set cannot program a pause or flash in a spd bin.
5. Hang up.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters:
0 ! “
# $ % & ’ ( ) ô Õ ú ä ö ü α ε θ
* Enter characters:
* + , - . / : ; < = > ? B E σ S ∞ ¢ £
## = Accepts an entry (only required if two letters on the same key are needed – ex: TOM).
Pressing
# again = Space.
Conf Clears the character entry one character at a time (used when entering the name).
Exit
Clears all the entries from the point of the flashing cursor and to the right (used when
entering the number, this clears both the number and name).
Key for Entering Names (Continued)
Use this keypad
digit . . .
When you want to. . .