NEC Univerge SV8100 - Page 954

Issue 5.0 UNIVERGE SV8100
1 - 944 Station Message Detail Recording
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
10-12-01 CD-CP00 Network Setup – IP
Address
Assign the IP Address. 0.0.0.0 ~
126.255.255.254
128.0.0.1 ~
191.254.255.254
192.0.0.1 ~
223.255.255.254
(default =
192.168.0.10)
10-20-01 LAN Setup for External
Equipment – TCP Port
Define the TCP port (0~65535)
when communicating to the SMDR
(type 5).
0~65535
default:
External Device 1 (CTI
Server) = 0
External Device 2
(ACD MIS) = 4000
External Device 5
(SMDR Output) = 0
External Device 6 (DIM
Output) = 0
External Device 11
(O&M Server) = 8010
10-20-03 LAN Setup for External
Equipment – Keep Alive Time
Use to define the keep alive time
for communicating to external
equipment.
1~255 (seconds)
(default = 30)
14-01-06 Basic Trunk Data Setup – SMDR
Printout
Use this option to have the system
include(1) or exclude (0) the trunk
you are programming from the
SMDR printout. Refer to Program
35-01 and 35-02 for SMDR
printout options.
0 = No Print Out
1 = Prints Out
(default = 0)
14-04-01 Behind PBX Setup For ANI/DNIS, the following
additional setting is
recommended: Behind PBX = 0
(Stand Alone).
0 = Stand Alone
(Trunk)
1 = Behind PBX (PBX)
2 = Not Used
3 = CTX assume 9
(default = 0)
15-01-03 Basic Extension Data Setup –
SMDR Printout
For each extension, enter 1 if
extension calls should appear on
SMDR report. Enter 0 if extension
calls should not appear on SMDR
report.
0 = Do not print on
SMDR report
1 = Include on SMDR
report
(default = 1)