NEC Univerge SV8100 - Page 957

UNIVERGE SV8100 Issue 5.0
Station Message Detail Recording 1 - 947
35-02-10 SMDR Output Options – All
Lines Busy (ALB) Output
Determine if the All Lines Busy
(ALB) indication should be
displayed.
0 = Not Displayed
1 = Displayed
(default = 0)
35-02-12 SMDR Output Options – DID
Table Name Output
Determine if the DID table name
should be displayed for incoming
DID calls.
0 = Not Displayed
1 = Displayed
(default = 0)
35-02-13 SMDR Output Options – CLI
Output When DID to Trunk
Determine if the Caller ID should
be displayed when the incoming
DID number is transferred to an
outgoing trunk.
0 = Not Displayed
1 = Displayed
(default = 0)
35-02-14 SMDR Output Options – Date Determine whether the date
should be displayed on SMDR
reports.
. This option must be set to 0 if
the trunk name is set to be
displayed in Program
35-02-03.
0 = Not Displayed
1 = Displayed
(default = 0)
35-02-15 SMDR Output Options – CLI/DID
Number Switching
Enter 0 to display the Caller ID
number. Determine if the Caller ID
number (0), DID number (1) or
Caller ID name (2) should be
displayed in the SMDR output.
0 = CLI (CLIP)
1 = DID Calling
Number
2 = Caller ID Name
(default = 0)
35-02-16 SMDR Output Options – Trunk
Name or Received Dialed
Number
Determine how the SMDR should
print incoming calls on ANI/DNIS
or DID trunks. If set to (1), ANI/
DNIS trunks can print DNIS digits.
For DID trunks, if the received
number is not defined in Program
22-11-01, a number is not printed.
If set to (0) trunk names are
printed instead (as assigned in
Program 14-01-01).
0 = Trunk Port Name
1 = Received Dialed
Number
2 = Both
(default = 0)
35-02-17 SMDR Output Options – Print
Account Code or Caller Name of
Incoming Call
Determine whether the Account
Code (0) or Caller ID name (1)
should appear in the SMDR
record. By default, the Account
Code is displayed.
. Program 35-01-08 must be
set to 0 for this entry to be
followed.
0 = ACC
1 = CNAME
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data