NEC Univerge SV8100 - Page 956

Issue 5.0 UNIVERGE SV8100
1 - 946 Station Message Detail Recording
35-01-07 SMDR Options – Minimum Ring
Time (For Incoming Calls)
Enter how long an unanswered
call must ring (1~65535 seconds)
before SMDR logs it as No
Answer). Enter 0 to allow all No
Answer calls to print.
0~65535 (sec)
(0 = All)
(default = 0)
35-01-08 SMDR Options – Format
Selection
This option is added to allow an
increased account code field from
eight to 16 when used in the U.K.
This allows 16 characters of the
Caller ID name to be displayed.
0 = NA Type (North
America)
1 = G/J Type
(Overseas/ Japan)
(default = 0)
35-02-01 SMDR Output Options – Toll
Restricted Call
SMDR can include or exclude calls
blocked by Toll Restriction.
0 = Not Displayed
1 = Displayed
(default = 1)
35-02-02 SMDR Output Options – PBX
Calls
When the system is behind a PBX,
SMDR can include all calls or just
calls dialed using the PBX trunk
access code.
0 = Not Displayed
1 = Displayed
(default = 1)
35-02-03 SMDR Output Options – Trunk
Number or Name
Select whether the system should
display the trunk name (0) or the
number (1) on SMDR reports.
. If this option is set to 0,
Program 35-02-14 must be
set to 0.
0 = Name
1 = Number
(default = 1)
35-02-04 SMDR Output Options –
Summary (Daily)
Set this option to (1) to have the
SMDR report provide a daily
summary (at midnight every night).
0 = Not Displayed
1 = Displayed
(default = 1)
35-02-05 SMDR Output Options –
Summary (Weekly)
Set this option to (1) to have the
SMDR report provide a weekly
summary (every Saturday at
midnight).
0 = Not Displayed
1 = Displayed
(default = 1)
35-02-06 SMDR Output Options –
Summary (Monthly)
Set this option to (1) to have the
SMDR report provide a monthly
summary (at midnight on the last
day of the month).
0 = Not Displayed
1 = Displayed
(default = 1)
35-02-07 SMDR Output Options – Toll
Charge Cost
Set this option to (1) have the
SMDR report include toll charges.
0 = Not Displayed
1 = Displayed
(default = 1)
35-02-08 SMDR Output Options –
Incoming Call
Enable this option (1) to have the
SMDR report include incoming
calls. If you disable this option (0),
incoming calls do not print.
0 = Not Displayed
1 = Displayed
(default = 1)
35-02-09 SMDR Output Options –
Extension Number or Name
Set this option (1) to have the
SMDR report include extension
numbers. Set this option (0) to
have the SMDR report include
extension names.
0 = Name
1 = Number
(default = 1)
Program
Number
Program Name Description/Comments Assigned Data