NEC Univerge SV8100 - Page 987

UNIVERGE SV8100 Issue 5.0
Tandem Trunking (Unsupervised Conference) 1 - 977
Method D – Tandem Trunking to Speed Dial Number
Program
Number
Program Name Description/Comments Assigned Data
11-10-06 Service Code Setup (for System
Administrator) – Setting the
Automatic Transfer for Each
Trunk Line
If the default service code (833) for
enabling Automatic Tandem
Trunking feature is not acceptable,
change the code as required.
MLT
(default = 833)
11-10-07 Service Code Setup (for System
Administrator) – Canceling the
Automatic Transfer for Each
Trunk Line
If the default service code (834) for
canceling Automatic Tandem
Trunking feature is not acceptable,
change the code as required.
MLT
(default = 834)
11-10-08 Service Code Setup (for System
Administrator) – Setting the
Destination for Automatic Trunk
Transfer
If the default service code (835) for
setting the destination of the
Automatic Tandem Trunking
feature is not acceptable, change
the code as required.
MLT
(default = 835)
13-04-01 Speed Dialing Number and Name
– Speed Dialing Data
Enter the number and names for
the bins used to hold the
Automatic Tandem Trunking
destination.
1~9, 0, *, #
Pause (Press line key
1)
Recall/Flash (Press
line key 2)
@ = Code to wait for
answer supervision in
ISDN (Press line key 3)
(maximum 24 digits)
(default not assigned)
13-04-02 Speed Dialing Number and Name
– Name
Assign a name to each System
Speed Dial bin.
Maximum 12
Characters
(Use dial pad to enter
name)
(default not assigned)
13-04-03 Speed Dialing Number and Name
– Transfer Mode
Assign the transfer mode for each
System Speed Dial bin.
0 = Not Used
1 = Internal Dial
2 = Incoming Ring
Group (IRG)
(default = 0)