EasyManua.ls Logo

NEC Univerge SV8100 - Page 989

NEC Univerge SV8100
1174 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
UNIVERGE SV8100 Issue 5.0
Tandem Trunking (Unsupervised Conference) 1 - 979
Trunk Disconnect Continue/Disconnect Codes
20-07-11 Class of Service Options
(Administrator Level) – Forced
Trunk Disconnect (analog trunk
only)
Turns Off (0) or On (1) an
extension to use Forced Trunk
Disconnect. This allows the
extension to disconnect an
Unsupervised Conference in
progress.
0 = Off
1 = On
(default = 0 for
COS 1~14)
(default = 1 for
COS 15)
24-02-07 System Options for Transfer –
Trunk-to-Trunk Transfer Release
Warning Tone
This timer starts when a trunk
begins talking with another trunk
(for example: Trunk-to-Trunk
Transfer, outgoing from trunk,
Tandem Trunking).
0~64800 (seconds)
(default = 1800
seconds)
24-02-10 System Options for Transfer –
Disconnect Trunk-to-Trunk
This timer starts after the
Trunk-to-Trunk warning tone is
heard.
0~64800 (seconds)
(default = 0 seconds)
24-04-01 Automatic Trunk-to-Trunk
Transfer Target Setup
Assign the Speed Dialing number
(0~1999) to be used as the
destination for the Trunk-to-Trunk
Transfer.
Trunks: 1~200
0~1999
(default = 1999
25-07-07 System Timers for VRS/DISA –
Long Conversation Warning
Tone Time
Determine the time a DISA caller
or any trunk-to-trunk (such as
Tandem Trunking) conversation
can talk before the Long
Conversation tone is heard.
0~64800 (seconds)
(default = 3600
seconds)
25-07-08 System Timers for VRS/DISA –
Long Conversation Disconnect
Time
Determine the time the system
waits before disconnecting a DISA
or any trunk-to-trunk (such as
Tandem Trunking) call after the
Long Conversation tone is heard.
0~64800 (seconds)
(default = 10 seconds)
Program
Number
Program Name Description/Comments Assigned Data
14-01-25 Basic Trunk Data Setup –
Continued/Discontinued
Trunk-to-Trunk Conversation
When Program 24-02-10 is set to
disconnect a trunk after the
defined time, determine whether
or not a user should have the
ability to use the continue/
disconnect code.
Entries:
0 = Disable
1 = Enable
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data

Table of Contents

Other manuals for NEC Univerge SV8100

Related product manuals