NEC Univerge SV8100 - Page 990

Issue 5.0 UNIVERGE SV8100
1 - 980 Tandem Trunking (Unsupervised Conference)
20-28-01 Trunk to Trunk Conversation –
Conversation Continue Code
When Program 14-01-25 is
enabled, determine the 1-digit
code the user should dial (0~9,
*,
#) to extend the conversation
length for the time defined in
20-28-03. If the Continue and
Disconnect codes are
programmed the same (e.g.,
#),
the system follows the "Continue"
operation. Using the Continue
code before the warning tone is
heard has no effect.
0~9, #, *
(default not assigned)
20-28-02 Trunk to Trunk Conversation –
Conversation Disconnect Code
When Program 14-01-25 is
enabled, determine the 1-digit
code the user should dial (0~9,
*,
#) to immediately disconnect their
call. Using the Disconnect code
before the warning tone is heard
disconnects the call.
0~9, #, *
(default not assigned)
20-28-03 Trunk to Trunk Conversation –
Conversation Continue Time
When Program 14-01-25 is
enabled, determine the time a call
is extended (0~64800 seconds)
when the user dials the Continue
code (defined in Program
20-28-01).
0~64800 (seconds)
(default = 0 seconds)
24-02-07 System Options for Transfer –
Trunk-to-Trunk Transfer Release
Warning Tone
This timer starts when a trunk
begins talking with another trunk
(for example: Trunk-to-Trunk
Transfer/Tandem Trunking).
When this timer expires, a warning
tone is heard. If Program
24-02-10 is set, the conversation
disconnects after that timer
expires. This timer is set again
when the external digit timer
expires. One of the trunks used
must be an analog trunk (or leased
line).
Entries:
0~64800 (seconds)
(default = 1800
seconds)
24-02-10 System Options for Transfer –
Disconnect Trunk-to-Trunk
Determine how long a
conversation continues (0~64800
seconds) after the timer in
Program 24-02-07 expires. If this
option is set to 0, the conversation
is disconnected immediately. This
program has no affect if Program
24-02-07 is set to 0. One of the
trunks used must be an analog
trunk (or leased line).
0~64800 (seconds)
(default = 0 seconds)
Program
Number
Program Name Description/Comments Assigned Data