UNIVERGE SV8100 Issue 5.0
Tandem Trunking (Unsupervised Conference) 1 - 981
Operation
Method A – Tandem Trunking from Conference
To set up a Tandem Call:
1. Place or answer first trunk call.
2. Press Conf softkey.
3. Place or answer second trunk call.
4. To set up the tandem call, press Conf twice.
. This sets up a Conference between you and both outside parties.
5. Press Transfer.
- OR -
25-07-07 System Timers for VRS/DISA –
Long Conversation Warning
Tone Time
Determine the time a DISA caller
can talk before the Long
Conversation tone is heard
(0~64800 seconds). If Program
25-07-08 is set to 0, the call is
disconnected after the timer
expires. This timer is set again
when the external digit timer
expires.
. If this option is set to 0, the
settings in PRG 24-02-07
and PRG 24-07-10 are
followed – not PRG 25-07-07
and PRG 25-07-08.
0~64800 (seconds)
(default = 3600
seconds)
25-07-08 System Timers for VRS/DISA –
Long Conversation Disconnect
Time
This timer determines how long
the system waits (0~64800
seconds) before disconnecting a
DISA call after the Long
Conversation tone is heard. This
program has no affect if Program
25-07-07 is set to 0.
0~64800 (seconds)
(default = 10 seconds)
80-01-02
(35)
Service Tone Setup – Basic Tone
Number
Used to Edit the warning service
tone within the system.
1~33
0 = No Tone
33 = Default Time Slot
Please refer to the
VS8100 Programming
manual for defaults
Program
Number
Program Name Description/Comments Assigned Data
To Next Page
Loading...
