NEC Univerge SV9100 - Page 85

UNIVERGE SV9100
Issue 1.0
System Maintenance Manual
73
Alarm
No.
Type
Name
Content of Alarm
Cause
Action
Recovery
35
Not set
CS Blocking
The link of the CSIU and
CS came off.
1. Outgoing noise.
Minor. Method of setting up
CS.
3. Wiring to connect CSIU
unit with CS.
4. Hard defect of CS.
5. Hard defect of CSIU.
Please confirm the
following matter when
happening frequently
when operating it.
1. Please confirm CS is
normally connected.
Minor. Please confirm
the wiring between
CSIU-CS is normal.
3. Please exchange CS.
4. Please exchange
CSIU.
The error is
recovered when
reconnecting or
exchanging it.
36
Not set
CS error
notification 1
CS detected the problem
occurring in the air
synchronous signal
between CS-CSIU, BBIC
reset was executed, and
it was restored
automatically.
1. Outgoing noise.
Minor. Method of setting up
CS.
3. Wiring to connect CSIU
unit with CS.
4. Hard defect of CS.
5. Hard defect of CSIU.
Please confirm the
following matter when
happening frequently
when operating it.
1. Please confirm CS is
normally connected.
Minor. Please confirm
the wiring between
CSIU-CS is normal.
3. Please exchange CS.
4. Please exchange
CSIU.
This error has
been recovered
when it is notified.
37
Not set
CS transmission
error.
Because CS had not
returned the response
to the control signal
from a main device
longer than the fixed
time, it was restored
automatically specifying
reset to concerned CS
with a main device.
1. Outgoing noise.
Minor. Method of setting up
CS.
3. Wiring to connect CSIU
unit with CS.
4. Hard defect of CS.
5. Hard defect of CSIU.
Please confirm the
following matter when
happening frequently
when operating it.
1. Please confirm CS is
normally connected.
Minor. Please confirm
the wiring between
CSIU-CS is normal.
3. Please exchange CS.
4. Please exchange
CSIU.
This error has
been recovered
when it is notified.