Nederman FlexPAK 800 Setting Manual

FlexPAK 800/1000
9
EN
1 Preface
Read all product documentaon and product idencaon plate carefully before
installaon, use, and service of this product. Replace documentaon immediately if lost.
Nederman reserves the right, without previous noce, to modify and improve its products
including documentaon.
This product is designed to meet the requirements of relevant EU direcves. To maintain
this status, all installaon, maintenance, and repair is to be done by qualied personnel
using only Nederman original spare parts and accessories. Contact the nearest authorized
distributor or Nederman for advice on technical service and obtaining spare parts. If there
are any damaged or missing parts when the product is delivered, nofy the carrier and the
local Nederman representave immediately.
(Include this when needed:
This manual is supplemented by an installaon and service manual.)
2 Safety
This document contains important informaon that is presented as either a warning,
cauon or note. See the following examples:
WARNING! Risk of personal injury.
Warnings indicate a potenal hazard to the health and safety of personnel, and how that
hazard may be avoided.
CAUTION! Risk of equipment damage.
Cauons indicate a potenal hazard to the product but not to personnel, and how that
hazard may be avoided.
NOTE! Notes contain other informaon that is important for personnel.
7.2 Filter cleaning in Standby mode .................................................................................................................. 37
7.3 Filter cleaning in Running mode ................................................................................................................. 37
7.4 Filter cleaning valve funcon ........................................................................................................................ 37
8 ATEX Duct Isolaon Valve sengs ................................................................ ............................................................. 38
8.1 Flush Cycle sengs ............................................................................................................................................ 38
8.1.1 FlushCy1(T) (Timer)
................................................................................................................................ 38
8.1.2 FlushCy2(T) (Timer) (Dual Funcon)
............................................................................................. 38
8.2 Tuning Duct Isolaon Damper sequence ............................................................................................... 38
8.2.1 FCDely(T) Parameter
............................................................................................................................. 38
8.2.2 FCDely(T) Parameter Calculaon See, Timing diagram
...................................................... 39
8.2.3 Default FCDely(T) Parameter Sengs
......................................................................................... 39
8.3 IsoVDly(T) Parameter Sengs ...................................................................................................................... 39
8.3.1 Default IsoVDly(T) Parameter Sengs
........................................................................................ 39
8.4 Default ClenCyl(T) Parameter Sengs .................................................................................................... 39
8.4.1 Procedure to set ClenCyl(T) Parameter
...................................................................................... 39
8.4.2 Sengs TH = Cleaning Pulse Time (FC Valve opening Time)
.......................................... 39
8.5 Total Filter Cleaning sequence me .......................................................................................................... 40
8.5.1 Sengs TL = Vacuum Load Time
.................................................................................................... 40
8.6 FC Start Impulse ................................................................................................................................................... 40
Appendix A: PLC sengs protocol
.........................................................................................41

Nederman FlexPAK 800 Specifications

General

Brand	Nederman
Model	FlexPAK 800
Category	Dust Collector
Language	English