USE AND MAINTENANCE MANUAL
NERONE MID
27
EN
5. INSTALLATION
The installation, and all the interventions on the equipment described in this instruction
manual, must be performed by qualified technical personnel and in compliance with
current regulations.
The device must not be installed in an area where risk of fire is present. When heat sources
are present, keep a side and rear distance of 0.6 m. If there are no other heat sources
present, 0.1 m is enough.
The device must be installed on a support structure built in non-flammable material,
suitable to support its weight. The structure must be safe in order to avoid sagging, falls
or tipping over of the device. Furthermore, it must not protrude by more than 0.3 m beyond
the device on all sides.
5.1. INSTALLATION SITE
The device cannot be installed and operated in ATEX classified environments, areas or
areas where explosive atmospheres may be present, the deposit of any dusts or other
substances must be eliminated with suitable cleaning in order to avoid starting fires/
explosions, especially with the heated surfaces.
5.1.1. FEATURES OF INSTALLATION SITE
The equipment was not designed for outdoor operation.
It is not allowed to install the equipment outdoors and in locations directly exposed to the
weather.
The equipment must be placed indoors, in a room ventilated and suitable for the purpose (e.g. kitchen).
It cannot be used outside the permitted usage and operating conditions.
PERMITTED ENVIRONMENTAL CONDITIONS
Ambient temperature min. + 15°C / max + 30°C
Air humidity max 90%
To Next Page
Loading...