NERONE MID
EN
34
8. USE
Before use, it is required to check that the oven is in perfect condition. In the presence of
faults, the equipment must be decommissioned and the Technical Assistance Service must
be contacted.
8.1. FIRST USE
Before switch-on, it is recommended to carefully clean the equipment and its components
as indicated in the chapter “CLEANING”.
When using the oven for the first it is suggested to perform an empty operation cycle
(heating the oven above 200°C), in order to remove the impurities on the construction
materials.
8.2. ACTIVATION
Do not start the equipment with wet hands or when there is contact with water.
Make sure that the oven door is closed before switch-on. If open, the safety microswitch is tripped and stops oven switch-on/
operation. It will resume operations once the door is closed.
To switch on the oven, proceed as described below according to the type of oven in your possession.
DIGITAL Version:
STEP ACTION IMAGE
1
Switch on the device by pressing the O/I main switch.
Note: at start-up the green light on the button turns on and the “stAnd
by” writing appears on the display.
MECHANICAL Version:
STEP ACTION IMAGE
1
Switch on the device by rotating the time knob.
Note: when switching on the oven the “ON” green indicator light turns
on.
To Next Page
Loading...
