NERONE MID - 8.3.5. H₂O Injection Adjustment (Only “Digital” Version); 8.3.6. Cooking with Core Probe and ∆°T (Only “Digital” Version)

NERONE MID
EN
38
8.3.5. H
2
O INJECTION ADJUSTMENT (ONLY “DIGITAL” VERSION)
To adjust the insertion of water in the cooking phase, proceed as described below.
STEP ACTION
1
During the programming phase, press the button
2 The writing “H2O” appears on the left hand display, the right hand display shows the injection percentage.
3
Press buttons or to adjust the injection percentage from OFF= off to 100 = maximum.
4
Press button during the cooking phase to manually inject water.
8.3.6. COOKING WITH CORE PROBE AND ∆°T (ONLY “DIGITAL” VERSION)
Toset the cooking mode with core probe and ∆°T , proceed as described below.
STEP ACTION
1
In the manual parameters setting, press the button
2
The right hand display changes from showing the cooking time to showing the probe temperature and the letter
“c” appears next to it, showing the core temperature
3
Press buttons or to set the temperature to be reached by the prove for the oven to stop cooking.
4
When button is activated again, the oven passes from differential cooking in “∆°T” mode indicated by letter “d”
In this mode, the left display changes from showing the absolute temperature to showing the “∆°T” (temperature
value which is added to the core temperature detected by the probe during the cooking phase).
The end of cooking is determined by the value set and detected at the core of the product by the probe.