NETGEAR FUSE - Control Your Device Using the Power Button; Sleep Mode

Turning Your Device Off
■ Press and hold the Power button until the Shut Down message appears.
Control Your Device Using the Power Button
The Power button is used to turn the NETGEAR Fuse Mobile Hotspot on or off and to choose which
information screen to display on the LCD.
Desired result
Action
Turn mobile
hotspot on
Press and hold Power button for 3-4 seconds
Turn mobile
hotspot off
Press and hold the Power button for 3-4 seconds
Wake up WiFi
signal and device
screen
Press and release the Power button.
Cycle through
screens
Press and release the Power button.
Sleep Mode
If there have been no transmissions or operation of your device, or if the battery has not been charged,
your device automatically enters sleep mode to save power.
In sleep mode, WLAN is disabled.
■ Press the Power button to turn the display on and exit sleep mode.
 WLAN function is enabled and WiFi devices can reconnect to the hotspot.
The time required to recover the network connection varies by environment, settings, etc.
Getting Started 12
DRAFT