NETGEAR FUSE - Access Point Name (APN)

■ In the Mobile Hotspot Manager, click Settings > General > Software and Reset.
You can:
● Back up and restore your hotspot’s configuration, if needed. See Export Settings and Import
Settings.
● Update your device’s software. See Update the Mobile Hotspot Software and Firmware.
● Reset some or all of your device’s settings. See Reset Your Device.
● Configure the hotspot to install tethering drivers (if needed) when device is connected via USB to
a Windows or Mac system. See TRU-Install.
The following information is displayed.
Item
Description
Download /
Backup Settings
Click Save to make a copy (export) of the hotspot’s current configuration, so
that you can restore it later if needed. See Export Settings.
Restore Settings
Click Choose file to use a previously saved copy of your device configuration.
See Import Settings.
Software Update
Click Check for update to see if a new version of your device’s software has
been released, and and if there is, download and install it. The last time you
checked is shown on the screen (Last checked at). See
Update the Mobile
Hotspot Software and Firmware.
Note: Software downloads count against your plan’s data limit.
Mobile Hotspot Manager (Browser) Interface 43
DRAFT