1. In the Mobile Hotspot Manager, click Settings > Router > Basic.
2. You can make changes to any of these fields. When you finish, click Submit.
The following information is displayed.
UPnP
Current state of the Universal Plug and Play feature (On or Off). (See Enable
UPnP.)
The routing hardware’s IP address on the LAN.
The routing hardware’s internal LAN subnet mask.
The IP address assigned to the hotspot by the computer to which it is tethered.
Passthrough
VPN connections are enabled (On) or disabled (Off). See Enable VPN
Passthrough.
This field enables (On) or disables (Off) DHCP. See DHCP.
DHCP IP Range
This specifies the starting and ending address of the range of IP addresses
available for your device to dynamically (that is, not permanently) assign to
computers connected to it. See
DHCP.
Mobile Hotspot Manager (Browser) Interface 52
To Next Page
Loading...
