Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
10-2 Troubleshooting
December 2003, M-10177-01
LEDs Never Turn Off
When the router is turned on, the LEDs turns on for about 10 seconds and then turn off. If all the
LEDs stay on, there is a fault within the router.
If all LEDs are still on one minute after power up:
• Cycle the power to see if the router recovers.
• Clear the router’s configuration to the factory defaults. This will set the router’s IP address to
192.168.0.1. This procedure is explained in “Restoring the Default Configuration and
Password” on page 10-7.
If the error persists, you might have a hardware problem and should contact technical support.
LAN or Internet Port LEDs Not On
If either the LAN LEDs or the Internet LED do not light when the Ethernet connection is made,
check the following:
• Make sure that the Ethernet cable connections are secure at the router and at the hub or
workstation.
• Make sure that power is turned on to the connected hub or workstation.
• Be sure you are using the correct cable:
When connecting the router’s Internet port to a broadband modem, use the cable that was
supplied with the broadband modem. This cable could be a standard straight-through Ethernet
cable or an Ethernet crossover cable.
To Next Page
Loading...
Need help?
General