Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
3-8 Connecting the FWG114P to the Internet
December 2003, M-10177-01
b.
Select the NAT option and click Next to follow the steps in the Setup Wizard to input the
configuration parameters from your ISP to connect to the Internet. If you choose not to use
NAT, each computer on the LAN connected to the FWG114P must have a valid public IP
address in the same subnet as the Wan port of the FWG114P. For more information on
NAT, please see “Single IP Address Operation Using NAT” on page B-8.
If you were unable to connect to the firewall, please refer to Troubleshooting “Basic Functions” on
page 8-1.
Connecting the FWG114P Wireless Firewall/Print Server to
the Internet
You are now ready to configure your firewall to connect to the Internet. There are two ways you
can configure your firewall to connect to the Internet:
• Let the FWG114P auto-detect the type of Internet connection you have and configure it.
• Manually choose which type of Internet connection you have and configure it.
These options are described below. Unless your ISP uses DHCP, you will need the parameters
from your ISP you entered in “Record Your Internet Connection Information” on page 3.
How to Auto-Detect Your Internet Connection Type
The Web Configuration Manager built in to the firewall contains a Setup Wizard that can
automatically determine your network connection type.
1. If your firewall has not yet been configured, the Setup Wizard should launch automatically.
To Next Page
Loading...
Need help?
General