Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
Connecting the FWG114P to the Internet 3-19
December 2003, M-10177-01
7.
Router’s MAC Address: This section determines the Ethernet MAC address that will be used
by the firewall on the Internet port. Some ISPs will register the Ethernet MAC address of the
network interface card in your computer when your account is first opened. They will then
only accept traffic from the MAC address of that computer. This feature allows your firewall
to masquerade as that computer by “cloning” its MAC address. To change the MAC address,
select “Use This Computer’s MAC Address.” The firewall will then capture and use the MAC
address of the computer that you are now using. You must be using the one computer that is
allowed by the ISP. Or, select “Use This MAC Address” and enter it.
8. Click Apply to save your settings.
9. Click Test to test your Internet connection. If the NETGEAR website does not appear within
one minute, refer to Chapter 8, “Troubleshooting.”
The remaining chapters in this manual describe how to configure the Advanced features of your
firewall, and how to troubleshoot problems that may occur.
To Next Page
Loading...
Need help?
General