NETGEAR GC110 User Manual

Hardware Specifications and Default Values
372
Insight Managed 8-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP Fiber Ports
Static 802.1Q tagging 256 VID = 1
Max member ports are equal to
the number of ports on the switch.
Learning process Supports static and dynamic MAC
entries
Dynamic learning is enabled by
default
Table 82. Traffic control
Feature Sets Supported Default
Storm control All ports Disabled
Jumbo frame All ports Disabled
Max = 9216 bytes
Table 83. Quality of service
Feature Sets Supported Default
Number of queues 7 N/A
802.1p 1 Enabled
DSCP 1 Disabled
Rate limiting All ports Disabled
Table 84. Security
Feature Sets Supported Default
802.1X All ports Disabled
MAC ACL 100 (shared with IP and IPv6
ACLs)
All MAC addresses allowed
IP ACL 100 (shared with MAC and IPv6
ACLs)
All IP addresses allowed
IPv6 ACL 100 (shared with IP ACL and MAC
ACL)
All IP addresses allowed
Password control access 1 Idle timeout = 5 mins.
Password = “password”
Table 81. Port characteristics
Feature Sets Supported Default

NETGEAR GC110 Specifications

General

Switch type	Managed
Quality of Service (QoS) support	Yes
Console port	RJ-45
Power connector	DC-in jack
SFP module slots quantity	2
Installed SFP modules quantity	-
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	8
Product color	Gray
10G support	No
MAC address table	- entries